Soldier-worn power and UxS controller connectivity
Power and Data for Drone Controllers
Power devices draw on batteries already in the kit, or AC when available. Cables carry power and data to the controller over one Nett Warrior connection.
Power
Run the controller off the batteries already in the kit
Each device takes power from a radio battery, a vehicle, AC, or solar, regulates it, and exports it to a drone controller or EUD — without adding a second battery type to the load plan.

S-PACE
SP02002NW-Y | SP02002SC-Y | SP02002NW | SP02002SC
In-line twist lock power adapter and charger. Powers the radio, charges its battery, and exports regulated power to a drone controller. Combat proven.
- Output
- 12 VDC nominal, 36 W max, 3 A
- Input
- 9 to 32 VDC, worldwide AC (110/240 VAC), solar
- Fits
- PRC-148, 152, 161, 163, TR-E, SC4200, SIR, MPU-4/5
- Rugged
- IP67, MIL-STD-810G, 0.35 lb, 3.39″ × 1.83″ × 1.52″

M-PACE
MP07001NW-Y
Dual twist lock power adapter and charger with simultaneous output and smart charging. Redundant, hot-swappable, and TSA compliant.
- Output
- 12 or 24 VDC, 3 A max; USB-PD optional with dongle
- Input
- 10 to 33 VDC, worldwide AC (110/240 VAC), solar
- Batteries
- Dual 148/152/161/163 twist lock, mixed state of charge OK
- Rugged
- IP67, MIL-STD-810G, 0.55 lb, 3.2″ × 2.2″ × 1.5″

MIPA
PA0178-P-NW | PA0178-P-SC | PA0178-P-SC2 | PA0178-P-Custom
Multi-Input Power Adapter. Lightweight dual twist lock battery scavenger that runs two batteries in parallel through a single output. Batteries hot swap with no loss of output.
- Output
- 12 V nominal, 5 A max (Nett Warrior limited)
- Terminations
- Nett Warrior, 2.5×5.5 mm barrel, Switchcraft 2-pin, custom
- Temperature
- Operating −30 to +55 °C; Arctic option for −62 °C storage
- Rugged
- IP67 (connectors mated), 3.64″ × 1.52″ × 1.13″, 18″ pigtail

Nett Warrior Pure 90 W AC Power Supply
C20590NW
NW receptacle to AC-DC wall, for garrison, TOC, or bench.
- Output
- 18 VDC, 5 A, 90 W
- Input
- 100 to 240 VAC, INTL plug
- Cable
- 3 ft (NGE90I24-P1J)

12 Volt Auto Cable — 3 ft — Nett Warrior
C20030NW
Nett Warrior female to 12 V auto, 3 ft. Vehicle power on the move.
- Input
- 12 V vehicle accessory socket
- Output
- Nett Warrior female
Drone control cables
One Nett Warrior connection carries power and data
The Tri-Bridge family merges radio data and CPS power into a single Nett Warrior connection at the controller. Standard and reverse Y geometries let you route the split to whichever side of the kit is cleaner.
Tri-Bridge
C42050NW | Power and data Y cable
USB 2.0 data from a Silvus SC4200 and 12 VDC from CPS powered accessories and more reach EUDs and drone controllers on one Nett Warrior connection. Validated with Kutta and Saronic.
- Length
- 54 in overall; 42 in trunk, 12 in power leg, 12 in data leg
- Ends
- NW 6-pin socket to EUD / drone controller; NW 6-pin plug to CPS powered accessories and more; ODU 10-pin plug to SC4200 AUX
Tri-Bridge RJ45
C42711-NW-RJ45 | RJ45 data / NW power Y cable
Opens EUDs and drone controllers to any radio with an RJ45 port. An Ethernet-to-USB 2.0 bridge sealed in the Y overmold converts radio Ethernet to USB; CPS powered accessories and more supply the power.
- Length
- 54 in overall; 42 in trunk, 12 in power leg, 12 in data leg
- Ends
- NW 6-pin socket to EUD / drone controller; NW 6-pin plug to CPS powered accessories and more; rugged RJ45 plug (male) to radio
- Data
- 100BASE-TX at the radio, USB 2.0 at the controller

Reverse Tri-Bridge
C42000NW REV B | C42500NW REV B | Power and data, reverse Y
Power and data for EUDs and drone controllers through one Nett Warrior connection. The reverse Y puts the controller and power connectors on the same side of the split for cleaner routing. Fully shielded.
- Length
- 54 in overall; 42 in trunk, 12 in power leg, 12 in data leg
- Ends
- NW 6-pin socket to EUD / drone controller; NW 6-pin plug to CPS powered accessories and more; data leg to radio
C42000NW
ODU 10-pin plug data leg to Silvus SC4200 AUX. USB 2.0 data.
C42500NW
RJ45 jack data leg for any Ethernet radio; bridged to USB 2.0.
Tri-Bridge USB-C
C42750-USB-RJ45 | C42700-USB-RJ45 | RJ45 data / USB-C power
Powers EUDs and drone controllers from any USB PD source while radio Ethernet reaches the controller as USB 2.0. Bridge and USB-PD sink sealed in the overmold. Fully shielded.
- Length
- 54 in overall; 42 in trunk, 12 in power leg, 12 in data leg
- Ends
- NW 6-pin socket to EUD / drone controller; USB-C receptacle (female), USB PD power in, 20 VDC max; rugged RJ45 jack to radio, 100BASE-TX
C42750-USB-RJ45
Standard Y. Power and data legs on the far side.
C42700-USB-RJ45
Reverse Y. Controller and USB-C on the same side.
Battery power cables
Scavenge power from the batteries you already carry
2590, 5590, and BA-5590 power brought to a Nett Warrior connection, with fuel gauges where the mission needs state of charge at a glance.

Reduced-Size 2590 / 5590 Scavenge Cable — Nett Warrior
C20020NW
Nett Warrior female to 2590/5590 scavenge plug, 2 ft.

Waterproof BA-5590 Connector Cap (with Fuel Gauge) — Nett Warrior
C20220NW
Nett Warrior female to waterproof BA-5590 12 V connector cap with fuel gauge, 3 ft.

LEO SAT COTS 2590 Dual w/ Fuel Gauge — Nett Warrior
C30900NW
Nett Warrior female to dual waterproof BA-5590 with fuel gauge, 3 ft.
Coming soon
PAD Data Junctions
The PAD line moves radio Ethernet into EUDs and drone controllers over Nett Warrior, with power passed through from the S-PACE or any Nett Warrior source.

PAD-X-DC
CPS-NWX-0001 | NW / Ethernet X-junction
Powers an EUD or drone controller from the S-PACE and sends its video to two radios at once: a Silvus SC4200 over USB and a second MANET radio over Ethernet to carry the feed to a rear echelon. An internal switch keeps the two radio networks isolated.
- Ports
- NW socket to controller; NW plug from S-PACE; NW plug to SC4200 (standard Silvus EUD cable); rugged IP67 RJ45, 100BASE-TX
- Power
- S-PACE pass-through, about 34 W left for the controller within the 36 W ceiling
- Size
- 3.69″ × 3.69″ × 1.42″ body, Tan 499, fully potted

PAD-DC
CPS-NWB-0002 REV D | NW-to-USB bridge, in-line
Carries Ethernet from a Silvus SC4200 into an EUD or drone controller through its Nett Warrior port, while S-PACE power passes straight through like a passive Y. Enumerates with the ASIX driver already in Android and the Nett Warrior EUD baseline, with no firmware to load.
- Ports
- Ethernet in (NW 6-pin, 100BASE-TX); S-PACE power in (NW); NW out to controller
- Power
- Pass-through up to 3 A; about 0.15 V added drop; board load under 1 W
- Protection
- AC-coupled Ethernet input survives NW cable mis-mate and blocks PoE; ESD on all data lines

PAD-DC RJ45
CPS-NWB-0002 | RJ45 data + NW power in, 3 ft pigtail out
Lightweight junction that stows in the radio pouch. Takes Ethernet from the radio on a rugged RJ45 and DC power from any Nett Warrior source, then delivers USB 2.0 Ethernet plus protected power to the EUD or drone controller on a single 3 ft Nett Warrior pigtail. No PoE required.
- Inputs
- IP67 RJ45, 10/100/1000, T568B; Fischer NW power plug, 10 to 34 VDC
- Output
- USB 2.0 Ethernet + power, 30 W design point, 10 V min at connector
- Protection
- Reverse polarity, surge, eFuse current limit, ESD per IEC 61000-4-2
- Size
- 2.64″ × 1.42″ × 2.28″, Tan 499, potted; MIL-STD-810H design target
Contracting
Connect with our contracting team
Combat Power Solutions LLC is a Service-Disabled Veteran-Owned Small Business. CAGE Code 886U6. Talk to us about quantities, lead times, custom terminations, and integration with your controller and radio baseline.








