Soldier-worn power and UxS controller connectivity

Power and Data for Drone Controllers

Power devices draw on batteries already in the kit, or AC when available. Cables carry power and data to the controller over one Nett Warrior connection.

Power

Run the controller off the batteries already in the kit

Each device takes power from a radio battery, a vehicle, AC, or solar, regulates it, and exports it to a drone controller or EUD — without adding a second battery type to the load plan.

S-PACE in-line twist lock power adapter and charger fitted to AN/PRC-163 and AN/PRC-152 handheld radios

S-PACE

SP02002NW-Y  |  SP02002SC-Y  |  SP02002NW  |  SP02002SC

In-line twist lock power adapter and charger. Powers the radio, charges its battery, and exports regulated power to a drone controller. Combat proven.

Output
12 VDC nominal, 36 W max, 3 A
Input
9 to 32 VDC, worldwide AC (110/240 VAC), solar
Fits
PRC-148, 152, 161, 163, TR-E, SC4200, SIR, MPU-4/5
Rugged
IP67, MIL-STD-810G, 0.35 lb, 3.39″ × 1.83″ × 1.52″
M-PACE dual twist lock power adapter and charger with two output pigtails

M-PACE

MP07001NW-Y

Dual twist lock power adapter and charger with simultaneous output and smart charging. Redundant, hot-swappable, and TSA compliant.

Output
12 or 24 VDC, 3 A max; USB-PD optional with dongle
Input
10 to 33 VDC, worldwide AC (110/240 VAC), solar
Batteries
Dual 148/152/161/163 twist lock, mixed state of charge OK
Rugged
IP67, MIL-STD-810G, 0.55 lb, 3.2″ × 2.2″ × 1.5″
MIPA multi-input power adapter running two twist lock batteries in parallel

MIPA

PA0178-P-NW  |  PA0178-P-SC  |  PA0178-P-SC2  |  PA0178-P-Custom

Multi-Input Power Adapter. Lightweight dual twist lock battery scavenger that runs two batteries in parallel through a single output. Batteries hot swap with no loss of output.

Output
12 V nominal, 5 A max (Nett Warrior limited)
Terminations
Nett Warrior, 2.5×5.5 mm barrel, Switchcraft 2-pin, custom
Temperature
Operating −30 to +55 °C; Arctic option for −62 °C storage
Rugged
IP67 (connectors mated), 3.64″ × 1.52″ × 1.13″, 18″ pigtail
Nett Warrior Pure 90 W AC power supply, C20590NW

Nett Warrior Pure 90 W AC Power Supply

C20590NW

NW receptacle to AC-DC wall, for garrison, TOC, or bench.

Output
18 VDC, 5 A, 90 W
Input
100 to 240 VAC, INTL plug
Cable
3 ft (NGE90I24-P1J)
12 volt auto cable, 3 ft, Nett Warrior female to vehicle accessory plug, C20030NW

12 Volt Auto Cable — 3 ft — Nett Warrior

C20030NW

Nett Warrior female to 12 V auto, 3 ft. Vehicle power on the move.

Input
12 V vehicle accessory socket
Output
Nett Warrior female

Drone control cables

One Nett Warrior connection carries power and data

The Tri-Bridge family merges radio data and CPS power into a single Nett Warrior connection at the controller. Standard and reverse Y geometries let you route the split to whichever side of the kit is cleaner.

Tri-Bridge

C42050NW  |  Power and data Y cable

USB 2.0 data from a Silvus SC4200 and 12 VDC from CPS powered accessories and more reach EUDs and drone controllers on one Nett Warrior connection. Validated with Kutta and Saronic.

Length
54 in overall; 42 in trunk, 12 in power leg, 12 in data leg
Ends
NW 6-pin socket to EUD / drone controller; NW 6-pin plug to CPS powered accessories and more; ODU 10-pin plug to SC4200 AUX
Tri-Bridge C42050NW power and data Y cable, coiled
C42050NW
Assembly drawing of the Tri-Bridge C42050NW power and data Y cable
C42050NW — standard Y

Tri-Bridge RJ45

C42711-NW-RJ45  |  RJ45 data / NW power Y cable

Opens EUDs and drone controllers to any radio with an RJ45 port. An Ethernet-to-USB 2.0 bridge sealed in the Y overmold converts radio Ethernet to USB; CPS powered accessories and more supply the power.

Length
54 in overall; 42 in trunk, 12 in power leg, 12 in data leg
Ends
NW 6-pin socket to EUD / drone controller; NW 6-pin plug to CPS powered accessories and more; rugged RJ45 plug (male) to radio
Data
100BASE-TX at the radio, USB 2.0 at the controller
Assembly drawing of the Tri-Bridge RJ45 C42711-NW-RJ45 Y cable
C42711-NW-RJ45

Reverse Tri-Bridge

C42000NW REV B  |  C42500NW REV B  |  Power and data, reverse Y

Power and data for EUDs and drone controllers through one Nett Warrior connection. The reverse Y puts the controller and power connectors on the same side of the split for cleaner routing. Fully shielded.

Length
54 in overall; 42 in trunk, 12 in power leg, 12 in data leg
Ends
NW 6-pin socket to EUD / drone controller; NW 6-pin plug to CPS powered accessories and more; data leg to radio

C42000NW

ODU 10-pin plug data leg to Silvus SC4200 AUX. USB 2.0 data.

C42500NW

RJ45 jack data leg for any Ethernet radio; bridged to USB 2.0.

Assembly drawing of the Reverse Tri-Bridge C42000NW with ODU data leg
C42000NW
Assembly drawing of the Reverse Tri-Bridge C42500NW with RJ45 data leg
C42500NW

Tri-Bridge USB-C

C42750-USB-RJ45  |  C42700-USB-RJ45  |  RJ45 data / USB-C power

Powers EUDs and drone controllers from any USB PD source while radio Ethernet reaches the controller as USB 2.0. Bridge and USB-PD sink sealed in the overmold. Fully shielded.

Length
54 in overall; 42 in trunk, 12 in power leg, 12 in data leg
Ends
NW 6-pin socket to EUD / drone controller; USB-C receptacle (female), USB PD power in, 20 VDC max; rugged RJ45 jack to radio, 100BASE-TX

C42750-USB-RJ45

Standard Y. Power and data legs on the far side.

C42700-USB-RJ45

Reverse Y. Controller and USB-C on the same side.

Assembly drawing of the Tri-Bridge USB-C C42750-USB-RJ45 standard Y cable
C42750-USB-RJ45
Assembly drawing of the Tri-Bridge USB-C C42700-USB-RJ45 reverse Y cable
C42700-USB-RJ45

NW C1 Cable

C20071NW  |  Nett Warrior male to female, 24 in

Nett Warrior plug to socket carrying power and USB 2.0 data. Shielded, 24 in (610 mm).

Assembly drawing of the NW C1 cable C20071NW, Nett Warrior male to female
C20071NW

NW-ODU USB Link Cables

C42100NW-ODU  |  C42200NW-ODU

Shielded 24 in (610 mm) USB 2.0 link, Silvus SC4200 AUX (ODU 10-pin) to Nett Warrior.

C42100NW-ODU

NW plug to ODU plug

C42200NW-ODU

NW receptacle to ODU plug

Assembly drawing of the C42100NW-ODU USB link cable, Nett Warrior plug to ODU plug
C42100NW-ODU
Assembly drawing of the C42200NW-ODU USB link cable, Nett Warrior receptacle to ODU plug
C42200NW-ODU

Battery power cables

Scavenge power from the batteries you already carry

2590, 5590, and BA-5590 power brought to a Nett Warrior connection, with fuel gauges where the mission needs state of charge at a glance.

Reduced-size 2590 / 5590 scavenge cable to Nett Warrior, C20020NW

Reduced-Size 2590 / 5590 Scavenge Cable — Nett Warrior

C20020NW

Nett Warrior female to 2590/5590 scavenge plug, 2 ft.

Waterproof BA-5590 connector cap with fuel gauge to Nett Warrior, C20220NW

Waterproof BA-5590 Connector Cap (with Fuel Gauge) — Nett Warrior

C20220NW

Nett Warrior female to waterproof BA-5590 12 V connector cap with fuel gauge, 3 ft.

LEO SAT COTS 2590 dual cable with fuel gauge to Nett Warrior, C30900NW

LEO SAT COTS 2590 Dual w/ Fuel Gauge — Nett Warrior

C30900NW

Nett Warrior female to dual waterproof BA-5590 with fuel gauge, 3 ft.

Coming soon

PAD Data Junctions

The PAD line moves radio Ethernet into EUDs and drone controllers over Nett Warrior, with power passed through from the S-PACE or any Nett Warrior source.

All three are in design now. Specifications below are design targets and may change.
PAD-X-DC Nett Warrior to Ethernet X-junction, Tan 499 potted body
In development

PAD-X-DC

CPS-NWX-0001  |  NW / Ethernet X-junction

Powers an EUD or drone controller from the S-PACE and sends its video to two radios at once: a Silvus SC4200 over USB and a second MANET radio over Ethernet to carry the feed to a rear echelon. An internal switch keeps the two radio networks isolated.

Ports
NW socket to controller; NW plug from S-PACE; NW plug to SC4200 (standard Silvus EUD cable); rugged IP67 RJ45, 100BASE-TX
Power
S-PACE pass-through, about 34 W left for the controller within the 36 W ceiling
Size
3.69″ × 3.69″ × 1.42″ body, Tan 499, fully potted
PAD-DC in-line Nett Warrior to USB bridge, Tan 499 potted body
In development

PAD-DC

CPS-NWB-0002 REV D  |  NW-to-USB bridge, in-line

Carries Ethernet from a Silvus SC4200 into an EUD or drone controller through its Nett Warrior port, while S-PACE power passes straight through like a passive Y. Enumerates with the ASIX driver already in Android and the Nett Warrior EUD baseline, with no firmware to load.

Ports
Ethernet in (NW 6-pin, 100BASE-TX); S-PACE power in (NW); NW out to controller
Power
Pass-through up to 3 A; about 0.15 V added drop; board load under 1 W
Protection
AC-coupled Ethernet input survives NW cable mis-mate and blocks PoE; ESD on all data lines
PAD-DC RJ45 junction with RJ45 data input and Nett Warrior pigtail output
In development

PAD-DC RJ45

CPS-NWB-0002  |  RJ45 data + NW power in, 3 ft pigtail out

Lightweight junction that stows in the radio pouch. Takes Ethernet from the radio on a rugged RJ45 and DC power from any Nett Warrior source, then delivers USB 2.0 Ethernet plus protected power to the EUD or drone controller on a single 3 ft Nett Warrior pigtail. No PoE required.

Inputs
IP67 RJ45, 10/100/1000, T568B; Fischer NW power plug, 10 to 34 VDC
Output
USB 2.0 Ethernet + power, 30 W design point, 10 V min at connector
Protection
Reverse polarity, surge, eFuse current limit, ESD per IEC 61000-4-2
Size
2.64″ × 1.42″ × 2.28″, Tan 499, potted; MIL-STD-810H design target

Contracting

Connect with our contracting team

Combat Power Solutions LLC is a Service-Disabled Veteran-Owned Small Business. CAGE Code 886U6. Talk to us about quantities, lead times, custom terminations, and integration with your controller and radio baseline.